Results 1 to 4 of 4
  1. #1
    2 Star Lounger
    Join Date
    Dec 2009
    Location
    Atlanta, GA
    Posts
    176
    Thanks
    0
    Thanked 0 Times in 0 Posts

    My Netgear WG111v3 wireless USB adapter has stopped working.

    I have it on a static IP that I set in TCP/IP. I've have the deleted and re-installed the software. All it does is cycle through the channels at times stopping at 10 and not going to 11 where I'm broadcasting. I've checked the MAC address on the router and it's one of the one to accept. When I pull up the Netgear Wizard and go to the About tab the IP address isn't listed it's blank. To me that's the problem but I don't know how to fix it. I've tried the Netgear forums with no help.

    What am I missing?

  2. #2
    Super Moderator satrow's Avatar
    Join Date
    Dec 2009
    Location
    Cardiff, UK
    Posts
    2,138
    Thanks
    102
    Thanked 208 Times in 181 Posts
    The possibility that the router (if it belongs or is tied to your ISP) has been push updated?

    With all wireless adapters, I always set Windows to control the connection, rarely had a problem - switch it over and try setting it up again.

  3. #3
    2 Star Lounger
    Join Date
    Dec 2009
    Location
    Atlanta, GA
    Posts
    176
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I own the router. It was working fine no nothing. I don't think it's DOA because it sees the router.

  4. #4
    Administrator
    Join Date
    Mar 2001
    Location
    St Louis, Missouri, USA
    Posts
    20,655
    Thanks
    2
    Thanked 635 Times in 568 Posts
    Have you tried resetting the router to factory defaults then changing to your normal settings?

    Joe

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •