Results 1 to 3 of 3
  1. #1
    3 Star Lounger
    Join Date
    Nov 2001
    Location
    Brisbane, Queensland, Australia
    Posts
    330
    Thanks
    10
    Thanked 0 Times in 0 Posts

    Hardware not recognised after sleep mode

    I bought myself one of these PCI-E PCI Express PCIE to USB 3.0 4 port Hub Front Panel + USB 2.0 Card Reader but I find that when the computer wakes from sleep mode, the system cannot find the USB 3 ports. To get them back, I have to open Device Manager and do a Scan for Hardware Changes . Anyone have any ideas on fixing this other than turn the computer off instead of letting it go to sleep?
    "Heading for the deep end"

  2. #2
    Super Moderator jwitalka's Avatar
    Join Date
    Dec 2009
    Location
    Minnesota
    Posts
    6,794
    Thanks
    117
    Thanked 799 Times in 720 Posts
    Can you find the card in Device manager?
    If so, right click on it and select properties. Check for a power management tab and uncheck "allow computer to turn off this device to save power".

    Also, you could check your BIOS for a power Management page and see if there's entry that allows you to disble S1.

    Jerry

  3. #3
    New Lounger
    Join Date
    May 2012
    Posts
    3
    Thanks
    0
    Thanked 0 Times in 0 Posts
    Quote Originally Posted by jwitalka View Post
    Can you find the card in Device manager?
    If so, right click on it and select properties. Check for a power management tab and uncheck "allow computer to turn off this device to save power".
    That's right, or just check the settings of your card in the special software that comes with the card, where you can probably find a solution.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •