Results 1 to 3 of 3
  1. #1
    2 Star Lounger
    Join Date
    Jun 2001
    Posts
    146
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Report columns (2000 SP-3)

    Hi,

    Is it possible with report columns to have each detail section start at the top of a column? I tried setting up a report with columns that go down, then across, and then played with the New Row or Col property of the detail section. The data still runs together, that is, the next section starts immediately after the previous section.

    Thanks,
    Bob

  2. #2
    Plutonium Lounger
    Join Date
    Mar 2002
    Posts
    84,353
    Thanks
    0
    Thanked 29 Times in 29 Posts

    Re: Report columns (2000 SP-3)

    I think you should try again, and check the settings carefully, for you describe the correct way to start each section at the top of a column:
    - Set Column Layout to Down, then Across in the Columns tab of File | Page Setup...
    - Set the New Row or Col property of the Detail section to Before Section.

  3. #3
    2 Star Lounger
    Join Date
    Jun 2001
    Posts
    146
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Re: Report columns (2000 SP-3)

    After a little more experimentation, I realized I had to adjust a date header too. I set the Date Header New Row or Col setting to Before Section and the Detail New Row or Col setting to None and it came out fine.

    Thanks,
    Bob

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •